hydraulic pressespresse idraulichehydraulic presses

BENDING PRESSES - HYDRAULIC PRESSES

300 ton movable piston press for straightening - AEM3

300 ton movable piston press for straightening.

Lower floor - machining / slots for T nuts on customer request
Movable table - machining / slots for T nuts at the customer's request
Installed power 18 KW
Thrust force of main cylinder 300 Tons
Operator side horizontal light 3050 mm
Vertical light 1070 mm
Main cylinder stroke 500 mm
Height of the worktop from the ground 775/1175 mm
Lower worktop size 3000x800 mm
Rapid descent speed 20 mm / sec
Working speed 3 mm / sec
Rapid rise speed 20 mm / sec.
PRESS BRAKE - 4200 ton. - AEM3

PRESS BRAKE - 4200 ton.

- PRESS WITH SPECIAL DRAWINGS 4200 ton.
- BENDING PRESS
- BENDING LENGTH 13000 mm.
- MACHINE LENGTH 14000 mm.
- MACHINE HEIGHT 6000 mm.
- UNMATCHED BENDING PRECISION
- HEMMING PRESS, LARGE SIZE BENDING PRESS, SYNCHRONIZED BENDING PRESS.
pressa piegatrice per tubi - AEM3

CUSTOMER WORKING IN THE BUILDING AND CONSTRUCTION OF BUCKETS FOR EXCAVATORS.

- POWER 250TON
- LIGHT BETWEEN OPERATOR SIDE SHOULDERS 2050mm
- LIGHT BETWEEN SIDE SHOULDERS 610mm
- PISTON STROKE 500mm
- COMPLETE WITH BLADE HOLDER ONLY
- MANUAL SPRING PRESS CONTROL +
BUTTON - COMPLETE WITH HYDRAULIC PALLET LIFTING WITH MANUAL DISTRIBUTOR CONTROL + BUTTON
PRESS FOR SIMULTANEOUS 2 FOLDS - AEM3

PRESS FOR SIMULTANEOUS 2 FOLDS.

- IDEAL FOR BENDING OF CALL ON TUBES WITH DIAMETER 10 "3/4 (858 mm. WIDTH PLATE) A D.48" (3830 mm. WIDTH PLATE) AND THICKNESS UP TO 60 mm. THIS ALLOWS YOU TO FOLD THE PRINCIPLE OF WORKING HALF THE TIME
- PRESS "COLUMNS 4"
- POWER 3000 ton. (N° 2 CYLINDERS 1500 ton. / CAD)
- LIGHT BETWEEN THE COLUMNS 4100X600 mm.
- LIGHT BETWEEN PLANS OPEN 1500 mm.
- STROKE OF HYDRAULIC CYLINDER 450 mm.
- SPEED 'DOWN / UP 200 mm/sec.
- SPEED 'MAX POWER AT WORK 10 mm/sec.
- VALVES EQUIPPED WITH CONTROL OF THE PRESS TO LEARNING SYSTEM AND FULL OF SAVING RECIPES, CYCLES TOTAL, PARTIAL CYCLES.
RESSES FOR BENCH STRAIGHTENING - AEM3

RESSES FOR BENCH STRAIGHTENING.

- “4 COLUMN” PRESS - POWER 600 ton
- SPAN 2500X700X1200 mm.
- STROKE 700 mm.
- SPEED 200/7-15/200 mm/sec.
- ELECTRONIC WORKING SPEED REGULATION
- COMPLETE WITH 300 ton
- BLANK HOLDER STROKE 400 mm. WITH 60 HOLES FOR 40 DIAMETER ELECTRODES
- SELF-LEARNING EQUIPMENT WITH DATA STORAGE AND OTHER ACCESSORIES
- LEVEL IV PROTECTION BARRIERS ON THE OPERATOR’S SIDE AND ON THE BACK SIDE AND WITH FIXED WIRE MESH PROTECTION ON THE REMAINING PRESS’S SIDES WITH BIMANUAL PUSH-BUTTON CONTROL PANEL
- PRESSES WITH HEATED MOULDS.